Technical Data; General Safety Regulations - EINHELL MK 225 Manual De Instrucciones

Anleitung MK 225 13.11.2001 15:49 Uhr
Description
1. Handle switch
2. Switch-plug block
3. Saw blade guard
4. Saw blade guard (movable)
5. Diaphragm coolant pump (not visible)
6. Pivot
7. Vise
8. Geared motor
9. Intake filter
10. Saw base
11. Stop
Please read the operating instructions carefully and
observe the safety regulations at all costs.
Keep the operating instructions with the cross-cut
metal saw.

Technical data

Voltage: 230 V 50 Hz
Power rating:
Motor speed:
Saw blade speed:
Vise span:
Jaw width:
Cutting range at 90°:
90 wide, 40 high; 76 x 55; 65 x 60
Cutting range at 45°: 60 wide, 40 high
Saw blade: 225 mm dia. x 32 x 2
Teeth:
Safety insulated
Radio suppression: to EN 55014 and EN 60 555
Designed in accordance with the relevant VDE
standards.
Features
Saw blade: HSS 225 dia. x 32 x 2, 120 teeth,
Art. No.: 45.020.20
Pitch circle for drive holes:
Longitudinal stop
Diaphragm coolant pump
It is imperative for the voltage of your power source
to comply with the data on the machine´s rating
plate. Equipment marked for 230 V duty can also be
operated from a 220 V mains.
Seite 7

General safety regulations

These safety regulations must be observed at all
cost in order to prevent accidents. The machine
may be damaged if you operate it incorrectly.
Never use the cross-cut metal saw where there
are fumes or combustible liquids.
Use only sharp saw blades that are in perfect
working order. Replace cracked or bent blades
immediately.
Always pull the plug out of the power socket
before converting or cleaning the machine.
If you operate the machine outdoors, it is
imperative to use a rain-water-protected coupling
and a rubber-insulated flexible cable (H07RN-F)
with rain-water-protected plug that are approved
for outdoor duty.
Keep the power cable safe from damage. Oil and
acid can cause damage to the cable.
Never carry the machine by its power cable.
Never remove the plug from the socket by pulling
1000 W
on the power cable.
Before switching on, make sure there are no
2850 rpm
tools, rubbish, etc. on the machine.
75 rpm
If you use a cable reel, the complete cable must
90 mm
be drawn off the reel. The conductor should have
90 mm a minimum cross-section of 1.5 mm
Do not overload the machine.
Secure all workpieces properly.
Keep children away!
Make sure of your footing whenever you saw
large workpieces.
Wear goggles, ear muffs and gloves. Use a hair-
120
net on long hair.
If the power cable needs to be replaced, call an
electrician.
After switching off, never halt the blade by
applying side pressure.
Keep your hands away from the saw blade.
With large and very large workpieces, always use
a support.
Saw with even pressure.
If the saw blade jams, switch off the motor (risk of
overheating).
Never load the machine so much that it cuts out.
Never cut workpieces that are too small to be
dia. 45/6
clamped securely.
Round mouldings and any other workpieces that
may twist because they lack a flat bearing surface
should never be cut without proper clamping.
Never remove jammed parts or off-cuts from near
a running saw blade. Turn off the machine first.
Make sure that off-cuts are not hit by the saw
blade.
GB
2 .
7