Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
just reach the blade (figure M).
REWINDING SPOOL IF LINE UNRAVELS
(USE ONLY .065 IN. ROUND DIAMETER
LINE) (FIGURES 0 & P)
NOTE: Hand wound spools are likely to
become tangled more frequently than Black
& Decker factory wound spools. For best
results, factory wound spools are
recommended.
To rewind spools, follow the steps below:
• Unplug the toot.
• Remove the empty spool from the tool
as described in "REPLACING THE SPOOL".
• Firstwind new line onto the uppermost part of
the spool.
• Feed 3/4 inch (19mm) of
cutting line into one of the line
anchoring slots.
• Wind the cutting line onto
the spool in the direction of
the arrow on the spool. Make
sure to wind the line on
neatly and in layers. Do not
crisscross (figure 0).
• When the wound cutting
line reaches the recesses (j),
cut the line. (figure P).
• Temporarily park the line in
the holding slots (k) on one side
of the spool as shown in the
inset in figure P.
• Repeat the above
procedure for the second
cutting line on the lower section of the spool.
• Fit the spool onto the tool as described in "REPLACING THE SPOOL".
CAUTION:
Before you begin trimming, only use the
appropriate type of cutting line. Ensure that cutting line is present in
both sections of the spool (figure M).
WARNING:
To avoid serious injury, switch off and unplug the
tool before performing any maintenance.
1. Keep the air intakeslotsclean to avoid overheating.
2. Your trimmer Fine can dry out over time. Tokeep your line intop condition,
store spare pre-woundspools or bulk linein a plastic,sealable bag with a
tablespoon of water.
3. Plasticpartsmay be cleaned by using a mildsoap and a damp rag.
4. The linecutter on the edge of the guard can dull over time. Itis recommended
you periodicallytouch-up the sharpness of the blade with a file.
iMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by
authorized service centers or other qualified service organizations,
always using identical replacement parts.
lO
Publicidad
Tabla de contenido
