Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CUTTING
LINE / LINE FEEDING
Your trimmer uses .065 inch (1.65 ram) diameter, ROUND
nylon line. During use, the tips of the nylon lines wilt become
frayed and worn and the special self feeding spool will
automatically feed and trim a fresh length of line. Cutting line will
wear faster and require more feeding if the cutting or edging is
done along sidewalks or other abrasive surfaces or heavier
weeds are being cut. The advanced automatic line feeding
mechanism senses when more cutting line is needed and feeds
and trims the correct length of line whenever it's required. DO
NOT BUMP unit on ground in attempt to feed line or for any other
purposes.
Use Black & Decker replacement spool Model No. DF-065.
• USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON
LINE. Do not use heavier gauge line as it will overload the motor
and cause overheating.
Do not use lighter gauge or serrated .065
inch (1.65 mm) line as it will cause overfeeding.
• Other replacement parts (guards, spool caps, etc.) are available
through Black & Decker service centers. To find your local service
location call: 1-800-544-6986 or visit www.biackanddecker.com.
WARNING:
The use of any accessory not recommended
by
Black & Decker for use with this tool could be hazardous.
REPLACING THE SPOOL (FIGURES M & N)
• Unplug the toot.
• Depress the tabs (a) and remove the spool cap (b) from the
spool housing (c) in the trimmer head (figure M).
• Replace spool with Black & Decker model # DF-065.
• Grasp empty spool (d) with one hand and spool housing with
other hand and pull spool out.
If lever (e)
(figure N) in base of housing
becomes dislodged, replace
in correct position before
inserting new spool into
housing.
• Remove any dirt and grass
from the spool and housing.
• Take the new spool and
push it onto the boss (f)
(figure N) in the housing.
Rotate the spool slightly until it
is seated.
• Unfasten the end of one of
the cutting lines and guide the
line into one of the eyelets (g).
figure N. The line should
protrude approximately 5-3/8
inches (136mm) from the
housing.
• Unfasten the end of the
other cutting line and guide
the line into the other eyelet.
The line should protrude
approximately 5-3/8 inches
(136mm) from the housing.
• Align the tabs on the spool
cap (a) with the slots (h) in the
housing (figure M).
• Push the cap onto the
housing until it snaps
securely into place.
NOTICE:
To
avoid tool
damage, if the cutting lines
protrude beyond the trimming
blade (i), cut them off so that they
@
Replacement
spool
Model #
DF-065
Publicidad
Tabla de contenido
