THOMSON WS04 Instrucciones De Utilizacion página 9

Pairing with Bluetooth enabled devices (Mobile phones/Tablets etc.)
1. Keep the speaker and device within 1 meter of each other.
2. Switch on the power button to turn on the speaker; the LED indicator will blink quickly in blue while
the speaker enters search mode.
3. Start the Bluetooth function on your mobile device and look for "WS04" in the Bluetooth device
list (depending on the Bluetooth version of your device you may have to enter pass code '0000').
4. After successfully connecting, the LED will change to solid blue.
Note:
• If the pairing was not successful, turn off the speaker and re-pair again.
• After successful pairing, paired devices will remember each other so there is no need to pair again
unless pairing information is deleted.
• To pair with a new device, just follow steps 1-4 above after un-pairing the existing device.
Re-connecting to a paired device
If the speaker does not connect to the last used device automatically, then you will need to select it
manually from the list of devices on your mobile device.
Manually disconnect existing Bluetooth pairing
Press Bluetooth button to disconnect with existing paired device, then pair with new device.
Hands-free phone calls, make sure mobile phone is paired with speaker
1. Press the "Hands-free" button to answer an incoming phone call.
2. Press again to end a call.
3. Use the volume buttons to change the volume of the call.
Volume +/- and Previous/Next
1. Control volume via the Bluetooth device itself.
2. Long press Volume +/- to go to Next or Previous track.
3. Short press Volume +/- to turn on/down volume.
Equalizer: Pop/Classic/Jazz/Rock
1. Press Pop to go to Pop performance.
2. Press Classic to go to Classic performance.
3. Press Jazz to go to Jazz performance.
4. Press Rock to go to Rock performance.
AUX-in port
You can connect any music device to the WS04 speaker via the AUX port using the cable included.
The speaker will not use the Bluetooth function while connected via this cable.
- EN 3 -