Troubleshooting - Fellowes Voyager A3 Manual De Instrucciones

TROUBLESHOOTING

Problem
No symbols showing in LCD screen
Ready screen does not come on after a long
period
Pouch does not completely seal the item
Item comes out the front of laminator again
Machine speed and noise varies during
lamination
Symbols on LCD screen not clear
How to stop machine when laminating?
Pouch is lost in the machine
Jamming
Pouch is damaged after lamination
STORAGE & EXTERNAL CLEANING
Switch off the machine at the wall. Allow the machine to cool.
The outside of the machine can be cleaned with a damp cloth. Do not use solvents or flammable materials to polish the machine.
Cleaning sheets can be used with the machine. When the machine is warm – run the sheets through the machine to clean any residue
off the rollers. For advanced Cleaning of the inside of the laminator, please see the section on the CleanMe function above. Use
Fellowes Laminator wipes (#57037) only for the internal cleaning. For optimum performance, it is recommended that cleaning sheets
(#53206 / #53207) are used with the machine regularly.
W.E.E.E.
Possible cause
Machine is not switched on
Machine is in a hot or humid area
Item may be too thick to laminate
Temperature setting may be incorrect (manual
operation)
Item too thick to laminate
Items of different thickness laminated
Machine is laminating
Pouch is jammed
Pouch was used 'open end' first
Pouch was not centred on entry
Pouch was not straight upon entry
Empty pouch was used
Damaged rollers or adhesive on rollers
This product is classified as Electrical and Electronic Equipment. Should the time come for you to dispose of
this product please ensure that you do so in accordance with the European Waste of Electrical and Electronic
Equipment (WEEE) Directive and in compliance with local laws relating to this directive.
For more information on the WEEE Directive please visit www.fellowesinternational.com/WEEE
Solution
Switch on machine at rear next to plug inlet
and at the wall socket, then press standby
button to left of LCD screen
Move the machine to a cooler and dry area
Pass through the machine again
Use AutoLam setting or check pouch
thickness is correctly selected and pass
through again
Choose thinner pouch (80mic) and try
again. Photocopy item and laminate
the copy
No problem – automatic AutoLam adjust-
ment to guarantee optimum laminating
conditions for varying items
Please refer to sections above or flow
diagram on previous page
Press "Reverse" [ ] to exit pouch or
"Left" [ ] to return to "home" menu
screen
Select reverse button and pull out the
item by hand or open laminator manually
via the LCD and follow steps described in
CleanMe
Open laminator manually via the LCD and
follow steps described in CleanMe
11