Troubleshooting - Fellowes Titan 125 Manual Del Usuario

TROUBLESHOOTING

Problem
No 'red' power on LED
Ready light does not come on after a
long period
Pouch does not completely seal the item
Pouch has waves or bubbles
Pouch is lost in the machine
Jamming
Pouch is damaged after lamination
Cannot open top cover to gain 'Easy
Access'
Small pouch is lost in the machine
Possible cause
Machine is not switched on
Machine is in a hot or humid area
Item may be too thick to laminate
Thickness setting may be incorrect
Thickness setting may be incorrect
Pouch is jammed
Pouch was used 'open end' first
Pouch was not centered on entry
Pouch was not straight upon entry
Empty pouch was used
Damaged rollers or adhesive on rollers
Top cover locking screw is still located on the
left side of the machine
Pouch may be too small to use without a
carrier
Solution
Switch on machine at rear next to plug
inlet and at the wall socket
Move the machine to a cooler and
dry area
Pass through the machine again
Check pouch thickness is correctly
selected and pass through again
Check pouch thickness is correctly
selected and pass through again
Select reverse button and pull out the
item by hand. Select the open machine
setting and clean the rollers.
Pass cleaning sheets (CRC# 53206)
through the machine to test and clean
rollers. Select the open machine setting
and clean the rollers with Fellowes
roller wipes (CRC# 57037).
Remove the screw then open the lid
as advised.
Select 'Easy Access' and open the
machine. Remove the pouch and
laminate small pouches with a carrier
or on a sheet of paper.
9