Tabla de contenido
Publicidad
BEFORE YOU LAMINATE
Use Fellowes
®
brand pouches for
best results. Select
correct pouch size
for laminated item.
COLD LAMINATION STEPS
1
2
Center item on clear side against
Slide power button to Cold
sealed edge; documents cannot
Setting and wait for green Ready
be repositioned once laminated.
Light.
HOT LAMINATION STEPS
1
2
Slide power button to Hot
Place item inside pouch against
the sealed edge. To prevent
Setting and wait for green
Ready Light.
jamming, use a carrier when item
is smaller than the pouch.
TROUBLESHOOTING
Problem
Cause
Ready Light does not go on after extended
Laminator is in a hot, humid area.
time.
Ready Light does not go on for cold
If you used the hot lamination setting before a cold lamina-
lamination.
tion session, the laminator may need time to cool down.
Laminated item may be too thick.
Pouch did not completely adhere to item.
Jamming
Laminated item was not immediately removed from
machine or small items were laminated without a carrier.
Pouch was not used.
Pouch was not centered or straight when fed through
Pouch/Document Entry.
WARRANTY
Fellowes warrants all parts of the laminator to be free of defects in material and workmanship
for 2 years from the date of purchase by the original consumer. If any part is found to be defec-
tive during the warranty period, your sole and exclusive remedy will be repair or replacement,
at Fellowes' option and expense, of the defective part. This warranty does not apply in cases
of abuse, mishandling or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
All manuals and user guides at all-guides.com
• Plug laminator into power
outlet.
• Position laminator so you
have enough space to allow
items to pass freely through
the machine.
CAUTION: Only use self-adhesive pouches when laminating with a cold setting.
3
Peel a small part of the protective
sheet away from document.
3
Place pouch, sealed edge first,
into laminator entry. Keep pouch
straight and use the edge guide
to center it.
Solution
Move laminator to a cool dry area.
Wait 90 minutes for laminator to fully cool down.
Pass through laminator a second time.
Press release lever, in back of laminator, to gently pull pouch
out of machine. Use cleaning sheet before laminating.
Always put item in a pouch.
Align sealed edge with Pouch/Document Entry. Use guide
to center.
4
Place pouch, sealed edge first,
into laminator entry. Keep pouch
straight and use the edge guide
to center it. Continue peeling the
protective sheet away.
4
To prevent jamming, immediately
remove laminated item from back
of machine. Let item cool on flat
surface for several seconds.
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. IN NO EVENT SHALL FELLOWES
BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES ATTRIBUTABLE TO THIS PROD-
UCT. This warranty gives you specific legal rights. You may have other legal rights that vary from
this warranty. The duration, terms and conditions of this warranty are valid world-wide, except
where different limitations, restrictions or conditions may be required by local law. For more
details or to obtain services under this warranty, please contact us or your dealer.
5
To prevent jamming, immediately
remove laminated item from back
of machine.
5
Before switching off laminator,
feed empty cleaning/carrier sheet
through machine to clean unit.
Need Help?
Please call our experts at Customer
Service. You'll find the numbers for
your nearest Service Centre on the
cover of this booklet.
3
Publicidad
Tabla de contenido
