Troubleshooting - Fellowes M5 95 Manual De Instrucciones

TROUBLESHOOTING

Problem
No 'ready' lamp after a long
The Power LED is flashing red
turned off
Pouch is lost in the machine
Jamming
Pouch is damaged after lamination Damaged rollers or adhesive on
ImageLast logo did not disappear
STORAGE & CLEANING
Switch off the machine at the wall. Allow the machine to cool. The outside of the machine can be cleaned with a damp
cloth. Do not use solvents or flammable materials to polish the machine. Cleaning sheets can be purchased for use with
the machine. When the machine is warm – run the sheets through the machine to clean any residue off the rollers. For
optimum performance, it is recommended that cleaning sheets are used with the machine regularly. (Cleaning sheet order
PRODUCT REGISTRATION / WORLDWIDE WARRANTY
Thank you for purchasing a Fellowes product. Please visit
benefit from product news, feedback and offers. Product details can be found listed on the rating plate positioned on the
rear side or underside of the machine. Fellowes warrants all parts of the laminator to be free of defects in material and
workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during
including that of merchantability or fitness for particular purpose, is hereby limited in duration to the appropriate
warranty period set forth above. In no event shall Fellowes be liable for any consequential damages attributable to this
product. This warranty gives you specific legal rights. You may have other legal rights that vary from this warranty. The
conditions may be required by local law. For more details or to obtain services under this warranty, please contact Fellowes
or your dealer.
6
Possible cause
Machine not switched on
Machine is in a hot or humid area
The laminator has gone in to Auto
Shut Off mode
The laminator is in Auto Shut Off
mode
Pouch is jammed
Pouch was used 'open end' first
Pouch was not centered on entry
Pouch was not straight upon entry
Empty pouch was used
rollers
Heavier material thickness
Solution
Switch on machine at the side and at the
wall socket
Move the machine to a cooler and dry area
reset itself
reset itself
Press release lever and pull out the item
by hand
Pass cleaning sheets through the machine
to test and clean rollers
Pass pouch through laminator a second
time
to register your product and