Initial Configuration - Royal IDRO Manual De Instalación, Uso Y Mantenimiento

6.3 INITIAL CONFIGURATION

'HSHQGLQJ RQ WKH W\SH RI LQVWDOODWLRQ WKH EHVW FRQ¿JXUDWLRQ QHHGV WR EH VHOHFWHG IRU VWRYH RSHUDWLRQ
Before proceeding, power up the stove using the safety switch on the rear.
Use the arrow buttons to scroll between the icons until reaching the setup menu
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the
d) Press and enter the value "54" using the
e) Press WR FRQ¿UP
f) 7KH FXUUHQW FRQ¿JXUDWLRQ ZLOO EH GLVSOD\HG
g) 7R FKDQJH WKH FRQ¿JXUDWLRQ SUHVV
h) Press WR FRQ¿UP
$IWHU KDYLQJ FKDQJHG WKH FRQ¿JXUDWLRQ D FRPPXQLFDWLRQ HUURU PHVVDJH PD\ EH GLVSOD\HG IRU D IHZ
VHFRQGV ,JQRUH WKLV DQG VZLWFK WKH VWRYH RII XVLQJ WKH VDIHW\ VZLWFK RQ WKH UHDU ZDLW D IHZ VHFRQGV
and switch it back on..
FOUR DIFFERENT CONFIGURATIONS ARE AVAILABLE:
CONFIGURATION 1
6HW WKLV FRQ¿JXUDWLRQ ZKHQ WKH VWRYH LV FRQWUROOHG E\ DQ H[WHUQDO WKHUPRVWDW RU WLPHU WKHUPRVWDW 
7KLV FRQ¿JXUDWLRQ FDQ DOVR EH XVHG WR VZLWFK WKH VWRYH RQ RU RII PDQXDOO\ RU E\ WLPHU ZLWKRXW XVLQJ DQ H[WHUQDO
thermostat, but rather leaving the two terminals jumpered as per the factory setting.
,Q WKLV FRQ¿JXUDWLRQ WKH VWRYH VZLWFKHV RII ZKHQ UHDFKLQJ WKH H[WHUQDO WKHUPRVWDW VHWWLQJ RU DOWHUQDWLYHO\
modulates output (to minimise fuel consumption) when reaching the set water temperature.
The stove will turn off also in case the water temperature continues to rise despite the modulation. In this case,
the stove will turn on only if the temperature difference between the value you set up and the real one is higher
than 20°C.
,Q WKLV FRQ¿JXUDWLRQ LW LV WKHUHIRUH UHFRPPHQGHG WR UHJXODWH D KLJK ZDWHU WHPSHUDWXUH H[ ƒ& 
CONFIGURATION 2
6HW WKLV FRQ¿JXUDWLRQ WR VZLWFK WKH VWRYH RQ RU RII PDQXDOO\ RU E\ WLPHU ZKHQ WKH VWRYH LV FRQQHFWHG GLUHFWO\ WR
the central heating radiators.
The stove will modulate output according to the room temperature read by the probe on the stove.
The "Eco-mode" function can be used to have the stove switch off or on based on the set room temperature.
7KH IURVW SURWHFWLRQ IXQFWLRQ FDQ DOVR EH VHW LQ WKLV FRQ¿JXUDWLRQ
CONFIGURATION 3
6HW WKLV FRQ¿JXUDWLRQ ZKHQ ZDQWLQJ WR FRQQHFW WKH VWRYH WR D VWRUDJH WDQN ZLWK FRLO
The stove will be controlled (switch on and off) based on the temperature read by the probe in the storage tank.
7KH IURVW SURWHFWLRQ IXQFWLRQ FDQ DOVR EH VHW LQ WKLV FRQ¿JXUDWLRQ
CONFIGURATION 4
6HW WKLV FRQ¿JXUDWLRQ ZKHQ ZDQWLQJ WR FRQQHFW WKH VWRYH WR D VWRUDJH WDQN ZLWKRXW FRLO
The stove will switch on based on the temperature read by the probe in the storage tank, and will switch off based
on the stove return temperature.
7KH IURVW SURWHFWLRQ IXQFWLRQ FDQ DOVR EH VHW LQ WKLV FRQ¿JXUDWLRQ
6RPH W\SLFDO LQVWDOODWLRQ GLDJUDPV DUH VKRZQ RQ WKH ODVW IHZ SDJHV RI WKH ERRNOHW
cod. 004772131 - 07/2013 - Royal
USE AND & MAINTENANCE
to go to the setup menu
buttons to scroll to and select submenu
DQG HQWHU WKH YDOXH RI WKH QHZ FRQ¿JXUDWLRQ XVLQJ WKH
and then press ;
WR FRQ¿UP
[30]
--0
; " ´ ZLOO ÀDVK RQ WKH GLVSOD\
buttons;
;
buttons;
41/136