Aiwa AV-D50 Manual De Instrucciones página 17

OPERATING TV, CABLE TV, VCR
AND CD PLAYER
To confirm the stored ID code
You can check the stored ID code by counting the indicator
blinking.
You can control basic functions of a TV, CABLE TV, VCR and
CD play(?r with this remote control.
T(3 ENTER THE ID CODE OF THE
EXTERNAL EQUIPMENT
MODE
Indicator
SELECT
DIGIT buttons
(o-9)
SET UP
Before attempting to control them, be sure to enter the ID code
of the external equipment to the remote control as follows.
1
2
3
4
Confirm the code number of the external
equipment.
See the ID code list in the "APPENDIX at the end of this
manual.
Press either the TV, CABLE, VCR or CD button in
the MODE SELECT area.
Press and hold the SET UP button for about 2.5
seconds.
Confirm that the indicator blinks twice while pressing the SET
UP button,
Press three DIGIT buttons which correspond to
the ID code of the external equipment.
For E?xample, if your CD player is an AIWA unit, the required
ID code is 124 or 157. In this case, press the DIGIT buttons
in the order of"1 ," "2 and "4" (or "1 ," "5" and "7" ).
After the third DIGIT button is pressed, the indicator blinks
twicf? indicating that the ID code is correct and is stored on
the remote control.
1
2
3
4
5
6
Press either the TV, CABLE, VCR or CD button.
For example, to check thf? stored code for CD player, press,
CD.
Press and hold the
SET IJP
button for about
2.5
seccmds
press
"g;, "(#,
and
"() ,,
Press"1 ;' and count the indicator blinks.
For example, in the case that the stored ID is "1 !57."
The indicator blinks once.
Press "2;' and count the indicator blinks.
The indicator blinks five times.
Press "3;' and count the! indicator blinks.
The indicator blinks seven times,
TO CONTROlL TV, CABLE TV, VCR AND CD
PLAYER
CHANNEL
VOLUME
DIGIT buttons
(O-9) and ENTER
MODE SELECT
VCR/CD
ll:Pause, ~: Stop,
POWER 144: Rewind,
P: Play,
ml: Fast forward
m
1 Press any button in the MODE SELECT areal (TV,
CABLE, VCR or CD),,
The remote control is ready to operate the selected mods
equipment,
2
Press one of the buttons indicated
abIDVe,
For the use of the O – 9 iand the ENTER buttcms, see the
instruction manual supplied with the unit to be controlled.
Other buttons indicated above have the same function which
you will find on the unit to be controlled,
Ffeenterthe ID CODE of the external equipment alter replacing
the batteries of the remote control.
If there are plural ID codes for external equipment in the
"APPENDIX," try each number listed until you can control the
external equipment.
EiVGL/SH 16