Aiwa AV-D50 Manual De Instrucciones página 7

A130UTTHEREMOTE CONTROL
Insertingbatteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6(AA)
When tc) replace the batteries
The maximum operational distance between the remote control
and the :sensor on the unit should be approximately 5 meters
(16 feet) When this distance decreases, replace the batteries
with new ones.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as well.
e If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage,
* The rernote control may not operate correctly when:
- The line of sight between the remote control and the remote
senscr in the display window is exposed to intense light, such
as dir,ect sunlight.
- Other remote controls are used nearby (those of television,
etc.)
Remote control operation
This remote control system allows you to operate other external
equipment besides the AIWA receiver. For details of the remote
control operation for other external equipment, see "REMOTE
CONTROU on page 16.
Hereupon, it is explained how to operate the Aiwa receiver.
Al\/V/+
RECEIVER
MUTE
POWER
RECEIVER
KEY
TUNER PRESET/
SURROUND
'uNcT'ONevOLuME
1
2
Press the AIWA RECEIVER button to set
remote control to the Aiwa receiver mode.
Press one of the buttons indicated above.
the
FUNCTION button
Each time this button is pressed, the sound source changes
FM (or AM)aJ +V3+V2-~Vl~CD+AUX+~ PHONO
cyclically.
a): Either band, which you have tuned in for the last time, (comes on.
TUNER PRESET/SURROUND buttons
Tune in the station which has been preset on the receiver.
To go to a higher preset number, press the UP>Pi button. To
go to a lower preset number, press the DOWN- button.
This button is also used when adjusting the speakers level
balance of the DSP, Dolby Pro Logic or 5.1 CH mocle.
m
It is not necessary to press the AIWA RECEIVER button each
time you operate the Aiwa receiver unless another mode has
already been set. (See "REMOTE CONTROU on page 16.)
If the receiver cannot be operated with thle remote
control
Follow the steps below with the remote control.
1
2
3
Press the AIWA RECEIVER button.
Press and hold the SET UP button for about 2.5
seconds.
The indicator on the top of the remote control blinks twice
while pressing the button.
Press the DIGIT buttons in the order c)f "4;' "O"
and "6."
15NGL/!3H 6