—.
~ and @ in the illustration
correspond
to the following
details.
@AM antenna
@FM antenna
@Speaker
system A
@. Speaker svstem B
II
@) Center speaker
CONNECTING
SPEAKERS
@
Speaker
terminals
Connect
front speakers
(system A and/or
B), a center speaker,
surround
speakers
and sub woofer to the corresponding
speaker
terminals
on the unit:
- the front speaker
cords to the FRONT
SPEAKERS
terminals
- the center speaker
cord to the CENTER
SPEAKER
terminals
- the surround
speaker
cords to the SURROUND
SPEAKERS
terminals.
- for more powerful
bass, the sub woofer (with a built-in amplifier,
Aiwa TS-W35
etc.) cord to the SUPER
WOOFER
KI jack
Speaker
impedance
Front
amd center
speakers
Use the same impedance
speakers
for both the front and center
ones.
The SPEAKER
IMPEDANCE
SELECTOR
on the rear should be
set to the position
that matches
the impedance
value of the front
and center speakers.
When using 4 ohm speakers,
set the selector
to IMP:4Q. When
using 8 ohm speakers,
set the selector to IMP:8Q. Please unplug
the AC cord before setting the selector.
Surround
speakers
and super
woofer
The SPEAKER
IMPEDANCE
SELECTOR
has no effect on the
SURROUND
SPEAKERS
terminals
and the SUPER
WOOFER
~ jack. For the surround
speakers
and sub woofer, use speakers
of 8 ohms or more.
Connecting
+ to +, – to – terminals
To get the proper sound effect, the speaker
terminals
on the unit
and the speaker
should be connected
with proper polarity;
the +
terminal
on the unit should
be connected
to the + terminal
on
the speaker
(and – to –).
m
Be sure to connect
the speaker
cords correctly
as shown
in
the illustration
on the right column.
Improper
connections
can
cause short circuits
in the SPEAKER(S)
terminals.
Do not leave objects generating
magnetism
near the speakers.
Front speakers
/
Lift
up the
terminal
flap,
insert the speaker
cord lead
into the terminal
slot, then
close the flap. Check that the
cord is connected
securely.
Surround
speakers
I
W"5
-1
d
.4
[H ,
Z,ld
,0
b
&
%
\
L
Sub woofer
#.---.--.-.._J
L___
~.
Center speaker
m
ENGLISH
4