Troy-Bilt 01902 Manual Del Propietário página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
GENERAL
MAINTENANCE
RECOMMENDATIONS
The pressurewasher warrant), does not cover itemsthat
have been subjected to operatorabuse or negligence,To
receive full value from the warranty, the operator
must
maintain the pressure washer as instructed
in this manual.
• Some adiustments will need to be made periodically
to
properly maintain your pressure washer.
• All maintenance in this manuaI and the engine owner's
manual shoutd be made at least once each season.
• Once a yearyou shouldclean or replace the spa_ plu&
cleanor replace the _r filter and check the spraygun and
adiustable noz_Jeextension assemblyforw_anA new spark
plugand cleanair filter assure proper fuel-air
mixtureand
helpyour enginerun be_r and last longer. Please re4er to
your engineowner'smanual formore details.
• If equipped with inflatable tires, keep the air pressure at
the value marked on the tire or within IS and 40 psi.
Before
Each
Use
I.
Check engine oil level.
2.
Check water inlet screen for damage.
3.
Check in-line filter for damage.
4.
Check high pressure hose for leaks.
5.
Check chemical iniection hose and filter for damage.
6.
Check spray gun and adjustable nozzle extension
assembly forleaks.
7.
Rinse out garden hose to flush out debris.
PRESSURE WASHER
MAINTENANCE
Check
and Clean
Inlet Screen
Examine the screen on the water inlet. Clean it if the
screen is clogged or replace it if screen is damaged.
Check
High
Pressure
Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover,
damage or movement
of couplings. If any of these
conditions
exist, replace the hose immediately.
_WARNING
Check
Chemical
Injection
Hose
Examine the filter on the detergent
tube and clean if
clogged.The tube should fit tightIy on the barbed fitting.
Examine the tube for leaks or tears. Replace the filter or
tube if either is damaged.
Cleaning
Chemical
Injection
Hose
If you used the chemical iniection hose, you must flush it
with clean water before stopping the engine.
I.
Place chemical injection
hose in a bucket full of clean
water.
2,
Slide adjustable nozzle for_ard
to low pressure
position. Flush for I-2 minutes.
3.
Shut off engine.
IMPORTANT:
Simply shutting OFF engine will not
release pressure in the system. When
the engine has
shut down, squeeze
the trigger
on the spray gun to
relieve
the pressure
in the hose.
Check
Gun and Adjustable
Nozzle
Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the trigger by pressing it and making
sure it "springs back" into place when you release it. Put
the safety latch in the ON
position and test the trigger.You
should not be able to press the trigger.
Check
In-Line
Filter
Refer to Figure 12 and service the in-line filter if it
becomes clogged, as follows:
Nozzle Extension
O-ri_
m

Publicidad

Tabla de contenido
loading

Tabla de contenido