Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
TROUBLESHOOTING
Problem
Pump
has following
problems:
failure
to
produce
pt_essure_
e_atie
pressure,
chattering,
loss
of pressure_ low water
volume.
Detergent fails to mix
with spray.
Cause
I.
Nozzle in low pressure mode.
2,
Water
inlet is blocked,
3,
Inadequate w_ater supply,
4.
Inlet hose is kinked or leaking.
5.
Clogged inlet hose strainer.
6.
Water
supply is over 100°F.
7.
High pressure hose is blocked or
leaks.
8.
Gun leaks.
9.
Nozzle is obstructed.
10. Pump is fault 7.
I,
Detergent
siphoning tube is not
submerged.
2.
Chemical filter is clogged or cracked.
3,
Dirty in-line filter.
4,
Nozzle is in high pressure mode.
Engine runs good at no-
Engine speed is too slow,
load but "bogs"
when
load is added.
Engine shuts down during
Out of gasoline,
operation.
Correction
I.
Pull nozzle backward for high pressure
mode.
2.
Clear inlet.
3.
Provide adequate water flow.
4.
Straighten inlet hose, patch leak.
5.
Check and clean inlet hose strainer.
6.
Provide cooler water supply.
7.
Clear blocks in outlet hose.
8.
Replace gun.
9.
Clean nozzle.
I0. Contact Authorized
service facility/,
I.
Insert detergent siphoning tube into
detergent.
2.
Clean or replace filter/detergent
siphoning tube.
3.
See "Check
In-Line Filter".
4.
Push nozzle forward for low pressure
mode.
Hove throttle control to FAST position. If
engine still "bogs down", contact
Authorized
service facility,
Fill fuel tank,
m
Publicidad
Tabla de contenido
