Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section 3: Assembly
,
Before connecting garden hose to w_ter inlet,inspect
inlet screen (Figure 6), Clean screen if it contains debris,
replace it if it isdamaged,DO NOT RUN PRESSURE
WASHER IF SCREENIS DAMAGED,
4,
Run water through garden hose for30 seconds to
cleanout any debris,Turn offwater,
IMPORTANT:
DO
NOT
siphonstanding water forthe
water supply, U se ONLY
coldwater (less t han 100¢'F).
5, Connect garden hose (notto exceed 50 feetinlength)
to water inlet.Tighten
by hand (Figure 6).
6,
Turn ON water and squeeze trigger on spray gun to
purge the pump system of air and impurities,
WARNING
adequate eye protection,
Checklist
Before
Starting
Engine
Review the unit's assembly to confirm you have performed
all of the following:
I.
Make sure handle is in place and secure.
2.
Check that oit has been added to the proper level in
the engine crankc_e.
3.
Add proper fuel to fuel tank.
4.
Check for properly tightened
hose connections.
5.
Check to make sure that there are no kinks, cuts, or
damage to the high pressure hose.
6,
Provide a proper water supply at an adequate flow.
7,
Be sure to read "SafeLy Rules" and "How To Use Your
PressureWasher"
before using the pressure washer.
t
Publicidad
Tabla de contenido
