Troy-Bilt 01902 Manual Del Propietário página 15

PREPARING THE UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
'_reeae" pump action. If you do not plan to use the pressure
washer for more than 30 days, follow this procedure:
NOTE= PumpSaver, model number 01559, is available as an
optional accessory. It is not included with the pressure washer.
Contact the nearest authorized service center to purchase
PumpSawr.
I. Flush detergent siphoning tube by placing the filter into
2.
.
4.
5.
a pail of clean water while running pressure washer in
low pressure mode (adjustable nozzle in the forward
position). Flush for one to two minutes.
Shut offthe engine and let it cool, then remove high
pressure and garden hoses. Disconnect spark plug wire
from spark plug,
Empw the pump of all pumped liquids by pulling the
recoil handle about 6 times.This should remove most
of the liquid in the pump.
Use PumpSaver to preventcorrosionbuild up and
freezing of pump.
Store unit in a clean, dry area.
, Freeze darnageis n o_€overed underwarranty,
CAUTION
• Always wear eye pro_ection when Using PumpSaver,
To use PumpSaver, make sure the pressure washer is
turned off and disconnected from supply water. Read and
follow aiI instructions and warnings given on the PumpSaver
container.
NOTE: PumpSaver will drip from pump after treatment
and wilt stain wood and concrete.
Protecting the Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump.This
prevents freeze damage and lubricates pistons and seals.
NOTE: If PumpSaver is not available, draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING THE ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
m