Features And Controls; Pressure Washer; Water Inlet - Troy-Bilt 01902 Manual Del Propietário

Features and Controls
2
KNOWYOUR PRESSURE WASHER
Read this owner's manual and safety rules before operating your pressure washer.
Compare the illustrations with your pressure washer to familiarize yourself with the locations of various controls and
adjustments. Save this manual for future reference.
Spray Gun
Recoil Starter
Throtsie Control Lever
Choke Lever
Pump equipped with Automatic
Coo_ Down System
Chemical Injection
&Water Inlet
Adjustable Nozzle Always attached to nozzle High Pressure Outlet -- Connection for high pressure
extension,Adjustable nozzle allows you to adjust spray hose.
pressure and spray pattern. DataTag (not shown, near teat of base plate) -
Air Filter Dry _/pe filter element limits the amount of Provides model and serial number of pressure washer,
dirt and dust that gets in the engine. Please have these readily available if calling for assistance,
Automatic Cool Down System -- Cycles water
through pump when water reaches 125%155_EWarm
water will discharge from pump onto ground.This system
_revents internal pump damage.
Chemical Iniection Siphon/Filter Use to siphon
detergent or other pressure washer chemicals into the low
pressure stream,
Choke Lever Prepares a cold engine for starting.
High Pressure Hose Connect one end to water
Oil Fill/Dipstick -- Check and fill with oil here.
Pump -- Develops high pressure.
Recoil Starter Used for starting the en_ne manually,
Spray Gun Controls the application of water Onto
cleaning surface with trigger device. Includes safety latch.
Throttle Control Lever Sets engine in starting mode
for recoil stariEer and stops a running engine.
Water Inlet -- Connection for garden hose,
pump and the other end to spray gun.