Troy-Bilt 01902 Manual Del Propietário página 6

Assembly
ASSEMBLY
IMPORTANT: Read entire owner's manual before you
attempt to assembleor operate your new pressure washer.
Remove Pressure Washer from
Carton
• Remove the parts ba_ accessories, and insert included
with pressure washer,
• Slice two corners at the end of" carton from top to
bottom so the panel can be folded down fiat, then
remove alt packing material
• Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
Main Unit
Goggles
Handle
High Pressure Hose
Spray Gun
Nozzle Extension
Oil Bottle
Parts Bag (which includes the following):
Owner's Manual
Engine Manual
Owner's RegistrarJon Card
Maintenance Kit
Handle Fastening Hardware Kit (which includes):
Carriage Bolts (2)
Plastic Knobs (2)
"L" Hooks (2)
Lock Nun (2)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if paris are missing or damaged, call the
pressure washer helpline at 1-888-611-6708. If calling for
assistance, pte_se have the mode{, revision, and serial
number from the model data decal available.
To prepare your pressure washer for operation, you
will need to perform these tasks:
I. Fill out and send in registration card.
2. Attach handle to main unit.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
Attach Handle
I. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with holes
on handle supports (Figure I).
Alig
Handle
Supports
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it wilt slide
over the handle supports.
2. Insert carriage bolts through holes from outside of unit
and attach a plastic knob from inside of unit (Figure 2),
Tighten by hand.
3_
Insert one "U' hook through hote iust under billboard
on left side of handle (viewing from rear of unit). Hold
hook in ptace with a pliers and attach Iocknut with a
7/16" wrench (Figure 3).