tau PROG Guia Del Usuario página 17

OPERATION
On/Off
To turn on the device, press any key. A brief presentation page is displayed, showing the software
version installed.
To turn off the device, scroll using keys "▲" or "▼" through to the item "shut down instrument"
and press "".
Note: The programmer turns off automatically after a period of inactivity of approx. 5 minutes.
Menu selection
Scroll through the various menu items using keys "▲" and "▼" and press "" to select. On sub-
menu pages, press "≡" to return to the main menu.
Parameter modifications
The pages that enable modifications to parameters have various commands:
- Increase or decrease parameter displayed by means of "+" and "-".
- Press and hold keys "+" or "-" for rapid increase or decrease of the value.
- To move the cursor to the left, press keys "" and "" at the same time.
- Press and hold keys "+" and "-" at the same time to reset the value.
- To confirm the value entered, press "".
- To exit without applying changes to the previous value, press "".
Programming a radio control in rolling code mode
This function enables the user to program radio controls in the series SLIM-R and BUG-R in
rolling code mode.
Programming a SLIM-R radio control
1. Select the radio control code and client code to assign to the radio control to be programmed;
note that for each radio control programmed, a different radio control code must always be
assigned. Note also that a self-learning receiver will ONLY accept radio controls with the
same client code.
2. Select the menu "ROLLING MENU" and press "".
3. Select the page "RADIOCONTROL CODE" to modify the relative code.
4. Select the page "CLIENT CODE" to modify the relative client code.
5. Select the page "SLIMR PROGRAM".
6. Set up the radio control for programming: Press and hold the two radio control keys at the
same time for at least 3 seconds. A series of 3 brief flashes indicates that the programming
mode has been enabled. Position the radio control above the area indicated by the drawing
on the instrument.
7. Press the key "" on the programmer.
8. Wait for the programming procedure. On completion, the operation is confirmed (positive
or negative). If the operation fails (the display shows the message "Progr. ERROR") repeat
programming from point 6. If the operation is successful, the message "Programming OK" is
displayed, in this case TAUPROG automatically increases the value "Radiocon. Code" and
the device is ready to create a new compatible radio control.
9. To program other radio controls consecutively, repeat the procedure from point 6.
TAUPROG 17