Hammer Drilling; Removing The Accessory Tool; Care And Maintenance - Hilti SF 14-A Manual De Instrucciones Original

6.3 Switching on
▶ Press the control switch.
Speed can be controlled steplessly right up to maximum by varying
how far the control switch is pressed in.
6.4 Screwdriving
1. Set the torque and operating mode selector ring to the required torque.
2. Set the forward/reverse switch to the desired direction of rotation.
6.5 Drilling
1. Set the torque and operating mode selector ring to the
2. Set the forward/reverse switch to the "forward" position.
3. Switch the drill / driver on. → page 12

6.6 Hammer drilling

SFH 14-A
1. Set the selector ring to the "Hammer drilling" position
2. Switch the drill / driver on. → page 12
6.7 Switching off
▶ Release the control switch.

6.8 Removing the accessory tool

1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Open the keyless chuck.
3. Pull the accessory tool out of the keyless chuck.
7

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance
tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as these can attack the plastic parts.
12 English
Printed: 19.06.2019 | Doc-Nr: PUB / 5071630 / 000 / 05
symbol.
.
2009597
*2009597*