Balanced Body Studio Reformer Manual Del Usuario página 26

How to install your Reformer with Tower
BEFORE BEGINNING ASSEMBLY
These instructions include a
parts list. Please use this list
to make sure you have all the
parts necessary for installation.
If you are missing a part,
please contact our customer
service department at
1-800-PILATES
(1-800-745-2837).
REQUIRED TOOLS
» 3/16" Allen Wrench (Included. GEN9280)
» 21mm x 1/2 inch wrench (Included. ALL0060)
PARTS FOR TOWER
DESCRIPTION
Vertical tubes with eyebolts installed
Horizontal tube with eyebolts,
safety strap, and corner connectors
Push Through Bar for slider assembly
Yellow trap springs
Blue trap springs
Roll down bar
Yellow long springs
Purple long springs
Single cotton loops (pair)
Push Through Bar slider assembly
Push Through Bar slider shoulder bolt
1. Loosen the setscrews in the circular tube receivers with
included Allen wrench (see Figure A).
24
Figure A: Loosen set-screws here.
2. Remove the vertical
PART NO. QTY
TRP0105 2
3. Place the top horizontal
TRP0100 1
707-287 1
SPR9002 2
SPR9004 2
710-010 1
SPR9006 2
SPR9461 2
101-005 1
N/A 2
619-202 2
Figure C
tower poles from the
box and place them
into the receiver bracket
on the end of the
Reformer. The knobs of
the sliders will be facing
outward as shown in
Figure B.
tube onto the two
vertical tubes which go
into the corner brackets.
Make sure when you
place the tubes into the
receiver that the loop is facing forward, towards the carriage,
see Figure C.
Knobs
outward
Figure B
Loop should face
the reformer.