Operations - Bissell POWERTRAK 1790 Serie Guia Del Usuario

Operations: Power On & Settings
1
To power ON, step on
the RED ON/OFF Power
Switch Pedal located
near the bottom on
the back side. Push the
lower Handle Recline
Pedal two times for an
even lower recline.
Tools
NOTE:
Crevice Tool and Extension Wand come pre-installed on the back of the vacuum.
The Long Reach Dusting Tool does not store on the vacuum.
6
www.BISSELL.com
2
Turn dial on foot to adjust to 1 of 5 height adjustments.
NOTE: For optimal cleaning, adjust to the lowest
practical setting. If your vacuum is difficult to push, or is
pushing larger debris, adjust to the next higher setting.
To attach any of
the included tools,
remove the lower
wand base from the
foot of the vacuum
and from both hose
clips. Insert the
desired tool firmly
into the hose end.
Crevice Tool
Use in narrow spaces
or along baseboards
and edges.
Extension Wand
Attach with desired
tool for longer reach.
Lowest Setting: For low pile
carpet and bare floors.
Medium Setting: For medium
pile carpet.
Highest Setting: For high pile
and most shag carpet. Adjust to
high setting if difficult to push.
TurboEraser™ Tool
Remove tool by pulling
away and downwards
from vacuum. For best
use, press the brush
gently down and pull
towards you in raking
motion; too much
pressure will cause
brush to stop rotating.
Long Reach
Dusting Tool
Use for dusting large
surfaces in your home
including tables,
curtains and other
furniture.