Controller Ciruit Board - Pontos AquaCycle 2500 Instrucciones De Montaje

7.10. Controller ciruit board

The controller circuit board is located in the
control box. It controls all the system's
electrical consumers.
The connecting terminals for the various
consumers are located inside the control box
on the circuit board.
Working on the circuit
board
The control box may
only be opened by a
skilled electrician.
Only a skilled
electrician may carry
out work on the
circuit board.
For the safety instructions, see the start of
chapter 7
The circuit diagram can be found in the
Appendix to this Operating Manual (see
chapter 13.1).
Fuses
The controller's fuses are located at the top on
the controller housing. Open the fuse covers in
order to change the fuses. The controller
housing cover must not be opened when you
do this.
The following fuses are used:
Miniature fuse 5x20mm 5A
Miniature fuse 5x20mm 2A
EN 56
Operating Manual AquaCycle 2500
Battery
The unit has a CR2032 (lithium button cell; 3
Volt) battery that supplies the clock module
when the unit is in the de-energised state. It is
located inside the control box on the circuit
board.
Battery change
The battery may only
be changed by a
skilled electrician.
Version 2.5