Adding A Packlite; Power Amplifier Model A1 (Optional); Connecting Multiple B1 Bass Modules - Bose L1 Model II Guía De Usuario

English English Dansk Deutsch Español Dansk

Adding a PackLite

Figure 8

Connecting the A1

amplifier to the power
stand
Français Deutsch Italiano Nederlands Español
®

power amplifier model A1 (optional)

Connecting multiple B1 bass modules

®
Using a PackLite power amplifier model A1 allows you to add one or two additional B1
modules to your system. Refer to the A1 owner's guide for detailed operating instructions.
1. Make sure the A1 amplifier power switch is OFF.
2. Plug one end of the supplied ¼" TRS cable into the Bass - Line Out connector on the
power stand. Plug the other end into the INPUT connector on the A1 amplifier.
3. Connect a B1 bass module cable from the OUTPUT connector on the A1 to a B1 bass
module. If desired, connect a second B1 to the first B1.
4. Plug one end of the AC power cord into the A1 amplifier and plug the other end into an
AC (mains) outlet.
5. Switch the A1 power switch to ON (I).
Power stand
Bass - Line Out
CAUTION: DO NOT stack more than four B1 modules in a column.
Français Svenska Italiano
PackLite ® power
amplifier
Nederlands Svenska
S S
YSTEM
Additional B1
bass modules
ETUP
15