Connecting A Second B2 Module - Bose L1 Model II Guía De Usuario

Svenska Nederlands
S S
YSTEM ETUP
Figure 9

Connecting two

B2 bass modules
16
Italiano Français Svenska

Connecting a second B2 module

®
Using a PackLite power amplifier model A1 allows you to add one additional B2 module to
your L1 model II system.
1. Make sure the A1 amplifier power switch is OFF.
2. Plug one end of the supplied ¼" TRS cable into the Bass - Line Out connector on the
power stand. Plug the other end into the INPUT connector on the A1 amplifier.
3. Connect a B2 bass module cable from the OUTPUT connector on the A1 to the B2 bass
module.
4. Plug one end of the AC power cord into the A1 amplifier and plug the other end into an
AC (mains) outlet.
5. Switch the A1 power switch to ON (I).
CAUTION: DO NOT stack more than two B2 modules.
Nederlands Español Français Deutsch Italiano
To power stand
To PackLite amplifier
Deutsch Español Dansk English English Dansk
Bass Module Out
OUTPUT