H
ow to use washer
1. Power (
)
• Use this button to turn the power On/Off.
2. Cycles
• Rotate the Cycle selector knob to select cycle
designed for different types of fabric and soil
levels.
• Each cycle has a preset Wash/Rinse temperature,
Spin speed, Soil Level, and Option (See page 13).
• The preset settings can be changed anytime
before Start.
NOTE:
This front load washer requires longer cycle time
and gets clothes much cleaner, yet is more gentle on
the fabrics, than top load washers. Washing time can
be reduced significantly for small loads or lightly
soiled loads by selecting Speed Wash cycle and
setting the Soil Level button at Light.
3. Start/Pause (
• Use this button to start/stop the washer.
NOTE:
If you do not press the Start/Pause button within
4 minutes of selecting a cycle, the washer
automatically turns off.
14
)
4. Delay Wash
• Allows the start of any cycle to be delayed for
1~12 hours.
• Choose the wash cycle for your load, and then
press the Delay Wash button once for one hour or
press the button again to increase the delay wash
time up to 12 hours in one hour increments.
5. Water Plus
• Adds extra water to the wash and rinse cycles for
superior results.
6. SpinSense
TM
• SpinSense
TM
can be used when there is a
vibration problem, especially on wood floor
installations.
• To operate SpinSense
Plus button for 3 seconds when the washing
machine is running on any cycle.
• When SpinSense
TM
has been selected, the Spin
Speed button light will blink on and off continually
to indicate that the SpinSense
selected.
• Push and hold the Water Plus button again for 3
seconds to cancel SpinSense
• Once SpinSense
TM
has been selected, if will
continue to function even if interrupted by a power
failure.
• 'SPINSENSE' option cannot be selected during
the spinning cycle.
7. Extra Rinse
• This option provides an additional rinse.
• Use this option to ensure the removal of detergent
or bleach residue from garments.
TM
press and hold the Water
TM
function has been
TM
.