LG WD-10587BD Manual Del Propietário página 22

T roubleshooting guide
Symptom
• Water supply is not adequate in area
• Water supply taps are not completely
• Water inlet hose(s) are kinked.
• The filter of the inlet hose(s) are clogged.
• Drain hose is kinked or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an imbalance
• If the laundry is still too wet at the end of
• Water overfills due to the faulty water
• Water level sensor has malfunctioned.
• Over load in motor.
• The washer experienced a power failure.
22
Possible Cause
open.
detection and correction system. If
individual heavy articles are loaded
(ex. bath mat, both robe, etc.) this system
may stop spinning or even interrupt the
spin cycle altogether.
the cycle, add smaller articles of laundry
to balance the load and repeat the spin
cycle.
• Is the door opened?
valve.
Solution
Check another tap in the house.
Fully open tap.
Straighten hose(s).
Check the filter of the inlet hose.
Clean and straighten the drain hose.
Clean the drain filter.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning.
Close the door.
❋ If "
" is not released, call for service.
Unplug the power plug and call for
service.
Close the water tap.
Unplug the power plug.
Call for service.
Restart the cycle.