Frontal Panel; Rear Panel; Operating Precautions - Optimus MT-1500 Manual De Instalación Y Funcionamiento

3.3 Frontal panel

(1) Channel volumes
(2) Power switch

3.4 Rear panel

(5) Power cord plug
(6) Power fuse
(7) Binding post output connectors
(8) Signal ground lift barrier strip

3.5 Operating precautions

Make sure that the AC mains voltage is the same as printed on the rear of the amplifier. Damage
caused by connecting the amplifier to improper AC voltage is not covered by the amplifier
warranty. Make sure the power switch is OFF before making system connections or plugging.
It is always a good idea to have the gain controls turned down during power-up to prevent speaker
damage if there is a high signal level at the inputs.
Always use a quality power outlet, and make sure it meets the power requirements. Low quality
power outlet, such as oxidized spring blades in the outlet or to small cable connected to the outlet,
etc, will have an adverse effect on the performance of the amplifier.
Use proper speaker cables to minimize the power loss in the cables. It is better to use spade lugs
than bare wire to connect the speaker system to the red binding posts.
MT-1500 / MT-3500 Version 1.0
MT-1500 / MT-3500
(3) Air in take grill
(4) Front panel indicators
(9) Operation modes switch
(10) Balanced phone jacks inputs
(11) Power voltage selector switch
(12) Low frequency bypass/sub filter switch
Power Amplifiers
Page 4 of 9