Setting up
4. Repeat step 1 – 3 with the
50 GB/MT
284705_silv_Funksteckdosen-Set_IP44_Content_ES.indd 50
ton
(A, B, C or D) on the
2
remote control. You can now
remotely switch a connected
device on or off. Once assigned
the process will complete.
other wireless socket.
Note: You can switch several
remote-controlled sockets on
and off at the same time using
the ON/OFF button
channel. In addition, you can
programme six remote controls
one after the other and use
them for individual receivers.
This means you can switch one
appliance on and off from up
to six different places. In this
case, synchronise every remote-
controlled socket with the chan-
nel of the remote control.
Note: The coding of the re-
mote control is maintained
when you change the battery.
Note: If you disconnect the re-
mote-controlled socket from the
power supply, the codings will
be permanently stored.
Deleting a code:
First repeat steps 1 – 2 to
delete a code.
Then push the desired OFF
of one
button of the Channel ON/
2
OFF button 2 (A, B, C or D)
you wish to delete on the
remote control during the
30 second timeframe.
You will then again have
30 seconds to delete more or
store a new code.
Deleting all codes:
To delete all codes, first repeat
step 1 – 2.
Then push the MASTER-OFF
21.06.17 15:39