Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LISTADO DE EMBALAJE
DESCRIPCIÓN
Lavadora a presión
Depósito de jabón
Pistola y varilla
Para rocío
Punta de pulverización de 40 grados
Punta para boquilla
turbo
Punta de pulverización
Manguera de alta presión
Manuel d'instruction
Guía de inicio rápido
FIGURA
Connect the high pressure hose to the
WARNING:
This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk
Set-up
pressure washer gun assembly by turning
of injury or death, user must read and understand operator's manual before using this product.
1
the fitting clockwise. Ensure the fitting is fully
Connect garden hose to pressure
tightened to the pressure washer gun.
washer water intake.
2
Assemble pressure washer gun to spray
wand.
1700 PSI / 1.2 GPM
ELECTRIC PRESSURE WASHER
GPW 1704
3
Insert high pressure hose into trigger
handle.
Insert the male end (A) of the wand
INSTALLING DETERGENT BOTTLE
into the female bayonet outlet (B)
firmly.
Unscrew the bottle from the assembly and fill with pressure
washer detergents/soaps only.
While pushing in the wand firmly, turn
4
ensure a leak-free connection.
clockwise until tabs lock into place to
trigger handle.
Insert the male end of the bottle into the female outlet on the
Insert high pressure hose into the pressure
While pushing in the bottle firmly, turn clockwise until tabs lock
washer.
into place to ensure a leak-free connection.
5
Turn on water at outlet.
Pull back the quick-connect collar
Push the spray tip into place
6
Run water hose for 120 seconds with the
Push the collar forward
motor in OFF position. This helps drain air
from the tank and lines.
120S
SPRAY TIP
APPLICATION
7 7
Connect power cord to wall outlet
White - Wide fan tip (40° )
Extension cord not recommended.
The white 40 degree tip, referred to as the "fan" tip creates the widest
best used for light or delicate cleaning applications. It is recommended
area of cleaning with relatively low pressure. This pressure washer tip is
40
O
for light cleaning on wood decks and other soft or delicate surfaces.
Turbo Nozzle Tip
8
Turn on Pressure Washer
to break down tough dirt and grime. The spray pattern can cover area of
This nozzle rotates in a zero to 15 degree circular motion spray pattern
IMPORTANT: Ensure water outlet is On
4 to 8 inches wide, depending on the distance between the tip and the
before turning power On to avoid damage
TURBO
surface being cleaned.
to the pump.
Missing parts, accessories or need a service center?
NOTE:
Do Not Return to Store
Call : 1-888-909-6757
with an Auto Start/Stop feature.
AUTO ON/OFF SWITCH: This Pressure washer is equipped
www.GreenWorksTools.com
To operate: Turn the power switch to the On (I) position. Pump will
pressurize and shut down immediately.
Rev:00
Once the trigger of the gun is depressed the unit will turn on.
Unit will shut off and be in standby mode when trigger is released.
10
QTD
1
1
1
1
1
1
1
1
1
1
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
