Sunbeam GCSBNC-100 Manual De Instrucciones página 6

3-WAY MOTION SMART
This feature automatically turns the iron off if left in one position too long to
avoid accidents.
IF YOU LEAVE IRON ON:
• Horizontally without moving it, or accidentally tip the iron over, it will
automatically stop heating after 30 seconds. The light turns red when auto-off
activates and blinks.
• Vertically (on its heel rest) without moving it, the iron will automatically turn
off after 15 minutes. The light turns red when auto-off activates and blinks.
IMPORTANT: When the auto-off feature has been activated, the indicator light
will blink.
TO RESET: Move iron back and forth and reheat until the "Ready" indicator light
turns solid green.
CARING FOR YOUR IRON AFTER USE
1. To turn off the iron, move the Steam Lever to Dry
iron.
WARNING: NEVER yank power cord when unplugging iron. This can damage
the cord.
2. If you do not use your iron on a daily basis, empty the water reservoir after
each use for a longer iron life. To do so, unplug the iron, turn the iron upside
down, open the Water Fill Hole Cover, and allow water to flow from the Fill
Hole. Shake the iron gently to remove trapped water drops.
AUTO-OFF FEATURE.
®
setting and unplug the
-E10-
STORING YOUR IRON
1. Unplug iron and allow to cool.
2. Empty water reservoir after each use and move Stem Lever to the Dry
setting.
3. Loosely loop the power cord around the iron and store iron in vertical
position on the Heating Base.
CAUTION: Wrapping the cord around the Heating Base too tightly can damage
the cord.
MAINTAINING AND CLEANING YOUR IRON
USING SELF-CLEAN FEATURE
Use the Self-Clean feature once a month to maintain optimal iron performance.
1. Unplug iron and remove from Heating Base.
2. Move Steam Lever back and forth to remove debris and minerals from
Steam Valve. This keeps water flowing into the steam chamber.
3. Fill water reservoir with tap water to MAX line.
4. Set iron and lock onto Heating Base the plug in iron and heat up for a
few seconds.
5. Unplug iron and remove from Heating Base. Holding iron over a sink in
a horizontal position, press Self-Clean Button and hold. Water will begin
dripping from the steam vents on the soleplate. Slowly rock iron side
to side and front to back for 30 seconds. Dip nose of the iron slightly
below the rear to circulate water. Release Self-Clean Button after one
minute.
6. Open Water Fill Hole Cover and empty remaining water. Carefully dry
soleplate with a towel after iron has cooled.
7. Plug in iron and heat for 1 minute to dry out completely. Unplug the
iron and allow to cool.
CLEANING SOLEPLATE
Clean soleplate after every 30 uses, or more frequently if starch is used or
build-up starts to accumulate. Before cleaning, ensure iron is unplugged and
cool.
WARNING: To avoid the risk of electric shock, do not immerse the iron in
water or other liquids.
Note: Do not use abrasive cleansers, scouring pads or vinegar to clean the
soleplate. This will damage the finish.
-E11-