ALPHA-TOOLS HLG 1500-2 Manual De Instrucciones página 8

Anleitung HLG 1500-2 AlphaTools
GB
● Only use extension cords with a mini-
mum cross-section area of 1,5 mm
● Repairs (for example power supply
cord replacement) should be perfor-
med only by a qualified electrician.
● Do not use chemical paint removers or
solvents at the same time as the hot
air pistol.
● Clean the nozzle when soiled.
● Be sure that the openings for air entry
and exit are always clean and free of
dirt.
● Hazardous or poisonous gasses can
be freed when removing paint. Be
sure to provide adequate ventilation
while working indoors.
● Never point the hot air directly at win-
dows or other glass surfaces.
Start of operation:
Be sure that the power supply voltage
matches that printed on the model
name-plate.
Choose the desired temperature and air
quantity with the ON/OFF switch (2). The
hot air pistol reaches the working tempe-
rature within one minute.
Switch position 1:
1st level - 375 °C / 400 l liters per minu-
te.
Center position:
The tool is switched off.
Switch position 2:
2nd level - 500 °C / 550 l liters per minu-
te
12.02.2004 7:14 Uhr
Possible uses for the hot air pistol:
2 .
1. Removal of paint and lacquer.
Attention! Hazardous or poisonous
gasses may be produced while
removing paint or lacquer. Be sure
to provide adequate ventilation.
2. Removal of stickers and decorations.
3. Loosening of rusted or tightly fastened
nuts and metal screws.
4. Thawing of frozen pipes, door locks,
etc. Attention: no not attempt to thaw
plastic or synthetic pipes.
5. Accentuation of natural wood grains
before staining or
lacque-ing.
6. Shrinkage of PVC packaging foils and
insulation tubes.
7. Waxing and de-waxing of skis.
Caution: Intensive heating means a
higher risk of fire and explosion!
Ensure good ventilation. Harmful
and/or toxic gases and vapors may be
emitted.
Choosing the right nozzle:
● The deflector nozzle (5) diverts the hot
air to protect glass etc. from overhea-
ting. Use it to strip paints.
● Use the fishtail nozzle (6) to distribute
the air uniformly over small areas.
● Use the cone nozzle (7) to confine the
heat to corners and small areas.
● Use the reflector nozzle (8) to solder
and shape pipes, to thaw frozen water
pipes and to heat shrink-down insula-
tion tubing.
Seite 8
8