1�
Close the tap�
2�
Select any procedure except "Wash" or "Drain" procedure�
3�
Press the button "Start/Pause" and keep the procedure running for about 40 seconds�
4�
Remove the inlet pipe from the tap�
5�
Wash the filter with water
6�
Reconnect the inlet pipe�
WASHING THE FILTER IN WASHING MACHINE
1�
Remove the inlet pipe from the rear of the machine�
2�
Pull out the filter with needle nose pliers rinse with water�
3�
Put the filter back into place�
4�
Reconnect the inlet pipe�
5�
Open the tap and make sure there is no water leakage�
6�
Close the tap�
REMOVING FOREIGN ITEMS FROM DRAIN PUMP FILTER
The drain pump filter can filter small foreign matters from clothing being washed� Clean the filter periodically to
ensure the normal operation of washing machine�
The pump should be inspected if the machine
does not empty and/or spin, or if it makes unusual
noises during draining due to objects (such as,
coins etc�) blocking the pump�
To access and clean the filter:
1�
Open the lower access cover� (Figure 19)
2�
Remove the emergency drain hose cap and
let water drain out� It is recommended to
have a vessel ready to catch remaining water�
(Figure 20)
3�
Replace emergency drain hose, and open
the filter by turning counter-clockwise�
(Figure 21)
4�
Remove any objects in filter and replace,
locking in by turning clockwise� (Figure 22)
WARNING: To avoid burning, it shall be done after the hot water inside the machine cools down�
WARNING: When the appliance is in use and depending on the program selected there may be hot water in the
pump� Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle,
and is empty� When replacing the cover, ensure it is securely in place�
THAW A FROZEN WASHING MACHINE
If the temperature drops below zero and your washing machine gets frozen, you may:
1�
Disconnect the power supply for the washing machine�
2�
Wash the tap connection with warm water to loosen inlet pipe�
Figure 18
Figure 19
Figure 21
20
Figure 20
Emergency
Drain Hose
Figure 22