BEFORE OPERATION
SETTING THE CLOCK
Po
DOLBY SURROUND
IER
MANUAL SELECT
VOLUME
I
II
Function indicators
I
PHONES
I
TAPE MONITOR
Function
buttons
FRONT SPEAKERS
A, B
To turn the unit on
Press one of the function buttons (TUNER, PHONO,
AUX, CD, VIDEO I, VIDEO 2 or VIDEO 3) or the TAPE
MONITOR button.
When pressing
the TUNER
button, the previously
tuned
station
is received
(Direct
Play Function).
The POWER
button
is also available,
Operation
is possible
after four seconds,
while the VOL
(volume)
level or function
name is displayed
one after the
other and the selected
function
indicator
flashes.
To select the front speaker system
To use speaker
system A: Set the FRONT SPEAKERS
A button
to -ON.
To use speaker
system
B: Set the FRONT SPEAKERS
B button
to sON.
To use both speaker
systems:
Set both the buttons to ~ ON.
Set the button(s)
to 10FF
to turn off the speaker
system(s).
m
As the front s~eaker
svstems
A and B are connected
in series:
- The sound
will dec;ease
slightly
when
using
both speaker
systems
- No sound can be heard if the FRONT
SPEAKERS
A and B
buttons
are set to -ON
when only one speaker
system
is
connected
When not connecting
a sub woofer
Be sure to select the "SUBW
OFF
mode.
After pressing
the DOLBY
SURROUND
button to turn on the
Dolby
Pro Logic,
press the MANUAL
SELECT
button
once
so that "SUBW
ON" appears
on the display.
Then press the
UPA
button within four seconds
to displav
"SUBW
OFF."
Using the headphones
Connect
headphones
to the PHONES jack with a standard
stereo
plug (06.3 mm, 1/4 inch).
Be sure to set the FRONT SPEAKERS
A and B buttons
to AOFF.
Otherwise
sound is output from the
speakers.
CLOCK
1
,y,5
2,4
When the AC cord is connected
for the first time, the clock on
the display
flashes.
Set the time as follows while the power is off.
1
2
3
4
Press the SET button.
The hour flashes.
Press the DOWNY
or UPA
button to designate
the hour.
Press the SET button to set the hour.
The hour stops flashing
and the minute
starts flashing,
Press the DOWNV
or
UPA
button to designate
the minute.
5
Press the SET button to set the minute.
The minute stops flashing
on the display
and the clock starts
from 00 seconds.
To
correct the current time
Press the POWER
button
to turn the unit off. Press the SET
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK
button
on the remote
control.
The clock
is
displayed
for 4 seconds.
To switch to the 24-hour standard
Press the POWER
button while pressing
the
UPA
or DOWNY
button while the current
time is displayed.
Repeat the same procedure
to restore the 12-hour
standard.
If the clock display flashes while the power is off
This is caused
by a power interruption.
The current
time needs
to be reset.
If power is interrupted
for more than approximately
24 hours, all
settings
stored in memory
after purchase
need to be reset.
When the headphones
are plugged
in:
- The Dolby Pro Logic or DSP system
is automatically
canceled
- The "DOLBY
DIGITAL SUR" or"3 STEREO"
mode of the Dolby
Digital Surround
is changed
to the "2CH STEREO
mode
To turn the unit off,
press the POWER
button.
7
ENGLISH