Activate Automatic Transmission (Asend) - Seca 374 Manual De Instrucciones

Activate automatic
transmission (ASend)
9. Confirm your selection for channel 2.
The device will suggest a channel number for chan-
nel 3 (here C3 "60").
You can either accept the channel number sug-
gested or select another channel number using the
arrow key.
10. Confirm your selection for channel 3.
StOp
The message
The device is waiting for signals from other equip-
ment devices with radio transmission capability
within its range.
NOTE:
With certain devices a special switch-on proce-
dure has to be followed if they are to be inte-
grated in a wireless group. Consult the user
manual for each device.
11. Switch on the equipment device you wish to inte-
grate in the wireless group, e.g. wireless printer.
A beep will be heard when the wireless printer is
detected.
NOTE:
As soon as you have integrated a wireless
printer in the wireless group, you have to select
a print option (menu\rf\APrt) and set the time
(menu\rf\time).
12. Repeat step 11. for all equipment devices you wish
to integrate in the wireless group.
13. Press the Enter key to end the search.
14. Press the arrow key to see which devices have
been detected (here: Mo 3 for a wireless printer).
Once you have integrated several devices in the
wireless group, press the arrow key several times to
check that all equipment has been detected by the
scales.
15. Press the Enter key to leave the menu or wait until
you leave the menu automatically.
You can configure the device so that the measured
results are automatically transmitted to all receivers that
are ready to receive and logged into the same wireless
group (e.g.: wireless printer, PC with USB wireless
module).
appears in the display.
seca 360° wireless Network • 51
English