Easy Troubleshooting - Subaru EA190V Manual De Instrucciones

When engine will not start:
Perform the following checks before you take the engine to your Subaru dealer. If
you still have trouble after completing the checks, take the engine to your nearest
Subaru dealer.
1. Is there a strong spark across the electrode?
• Is the stop switch at the position "I" (ON)?
• Remove and inspect the spark plug.
If the electrode is fouled, clean or replace it with new one.
• Remove the spark plug and connect it to the plug cap.
Pull the starter handle while grounding spark plug against engine body. Try
with a new spark plug if the spark is weak or there is not spark.
The ignition system is faulty if there is no spark with a new spark plug.
2. Is there enough compression?
Pull the starter handle slowly and check if resistance is felt. If little force is
required to pull the starter handle, check if the spark plug is tightened fi rmly. If the
plug is loose, tighten it.
3. Is the spark plug wet with gasoline?
• Is the fuel valve opened?
• Choke (close choke lever) and pull the starter handle fi ve or six times.
Remove the plug and check if its electrode is wet. If the electrode is wet, fuel
is well supplied to your engine.
• When the electrode is dry, check where the fuel stops. (Check the fuel intake
of the carburetor)
• In case the engine does not start with well supplied fuel, try using fresh fuel.
EA190V us_EU7115.indd 14 EA190V us_EU7115.indd 14

EASY TROUBLESHOOTING

▲
! WARNING
• Wipe out spilled fuel carefully before testing.
Place spark plug as far away from spark plug
hole as possible.
• Do not hold spark plug by hand while pulling
recoil starter.
14
2010/11/15 19:49:48 2010/11/15 19:49:48