Korg Keytar RK-100S Manual De Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. SOUND lever
This selects the program. Move the lever to the + or -
direction to switch to the next or previous program.
Tip: The SOUND lever can also be used to specify settings
for the shift functions.
8. TAP button
This specifies the tempo (speed) of the arpeggiator, LFO
or delay effect.
The tempo is specified according to the number of times the
button is pressed. The LED will blink in synchronization
with the tempo.
In addition, hold down the SHIFT button and press
this button to play the demo song (see 9 page "Demo
performance").
9. ARP button
This turns the arpeggiator on/off (see 13 page "Playing
arpeggios").
In addition, hold down the SHIFT button and press this
button to change the settings of the arpeggiator.
10. SHORT RIBBON button
This switches the parameter that's controlled by the short
ribbon controller.
When the button is lit up in red, the pitch of the sound can
be controlled.
When the button is lit up in green, the modulation of the
sound can be controlled.
In addition, if you hold down the SHIFT button and press the
Front and side panels
SHORT RIBBON button, the audio input signal from the INPUT
jack will be sent from the Output jack without modification.
11. SHIFT button
Hold down this button and press the corresponding button
to play the demo song or specify settings for the shift
functions.
12. Favorites buttons A – H
Your favorite programs can be assigned to these buttons.
The program can be quickly recalled by pressing the
corresponding button.
See page 9 "Favorites function"
In addition, hold down the SHIFT button and press one of
the favorites buttons (A – H) to enter a shift function and
change the settings for the function.
13. Output jacks [stereo jack]
You can connect powered monitors, a stereo amp, mixer,
or headphones to these jacks.
1
5

Publicidad

Tabla de contenido
loading

Tabla de contenido