Residual Risk - Zhermack VIBRATOR A11 Manual De Uso Y Mantenimiento

MAINTENANCE AND USE MANUAL
Fig. 8: After positioning the container, adjust vibration
intensity by turning the Electronic Regulator (3)
clockwise. The latter has an incorporated switch:
turning clockwise switches on the equipment, causing
the red indicator light (5) to come on.
Intensity of vibration varies from a minimum to a maximum in line with the set-
tings numbered from 0 min to 10 max on the Electronic Regulator dial.
Fig. 9: Once work has been completed switch off the
equipment by turning the Electronic Regulator
anticlockwise until you hear a click: this indicates it has
been switched off. The red indicator light (5) goes out.
Finally, remove the plug from the mains socket.
Residual risk is:
• a danger that cannot be completely eliminated through design and application of safety devices;
• a potential danger which cannot be highlighted.
The above residual risks are highlighted by the on-cleaner labels as described in paragraph 3.3.1.
To prevent accidents always observe the instructions in this handbook. Should you
have any doubts at all please contact the Manufacturer or your Authorised Servicing
Centre.
VIBRATOR A11/A12
EN
5
3
2
A 1
8
Figure
3
2
A 1
9
Figure

RESIDUAL RISK

7.5
107 of 176