EINHELL SS 1500 Instrucciones De Manejo página 6

Anleitung SS 1500
GB
3
Fit the two clamping nuts (16) with the M8x16 oval head
screws (12) and the 8.4 diameter U-washers (13) as
shown. Only position the screws.
5
Adjust the clearance and hang the profiled rail (3) with
the two hook-in brackets (2) in the previously fitted
clamping nuts (16). Adjust the profiled rail so it projects
approx. 5-6 cm over the rear bracket of the machine.
Tighten the screws (12) with hand force.
7
Now push the pre-assembled carrier frame onto the
carrier profile (3). You can adjust the bottom rollers in
the slots provided. Now fit the adjusting disks (6) to the
two feet (5) as shown. Insert the nuts (11) in the profiled
rail so they are flush. Fit the feet with the oval head
screws (10) and secure.
6
09.11.2001 10:38 Uhr Seite 6
4
Now fit the two hook-in brackets (2) with the M8x16
machine screws (14), the U-washers (13) and the nuts
(11) as shown. Only position the screws.
6
Screw the rollers (63) with the pre-assembled ball
bearing (65) and lock ring plus spacer sleeves (67) in
the carrier frame (51) as shown. Use the oval head
screws (73) with the washers (72) and the nuts (74).
8
Insert the oval head screws (10) through the carrier
frame from underneath and position the square nuts (71).
Then position the slots of the section (71) against the
nuts and insert. Half tighten the section approx. 10 mm
from the edge of the table. With the adjusting disks (6)
you can now adjust the two tables so they are parallel in
height and distance. Then fully tighten all the screws.