EINHELL SS 1500 Instrucciones De Manejo página 7

Anleitung SS 1500
9
Fit the fixing bracket, the carrier section and the holder
as shown. Make sure that the holder (62) is screwed a
distance of 40 mm from the edge of the inside of the
table.
11
Pre-assemble the parallel fence with the positioned
parts as shown.
Operating and adjusting
Caution: Make adjustments only when the
machine is switched off
The sliding carriage can be used for a variety of
operations.
1. The parallel fence (54) is infinitely adjustable in
cross direction relative to the saw blade.
2. The parallel fence (54) can be extended by
approx. 1000 mm for very long workpieces by
pulling out the U-profile (57).
3. A supplied workpiece fence (56) is also infinitely
adjustable on the parallel fence.
4. The angle setting (53) can be adjusted from 0 - 45
degrees.
5. The carriage travel equals 1180 mm.
09.11.2001 10:38 Uhr Seite 7
10
Now fit the adjusting bracket with the clamping shaft and
the clamping lever as shown.
12
Finally, mount the parallel fence as pre-assembled using
the existing screws and nuts.
Maintenance
The ball bearings are lubricated for life and require no
further lubrication.
All moving parts should be cleaned occasionally and
treated with a drop of acid-free lubricating oil. Do not
use aggressive detergents on aluminium parts and
painted parts.
GB
7