Giropes Baxtran BR20 Manual De Usuario página 25

6.4.2. Set limits
Press and key together, it will display
to enter, use and
value. After you enter the value, press
6.4.3. Set check weighing mode
Press and key together, it will display
press key to select
press key to escape.
6.4.4. Note
Checkweighing function only available when weight more than 20d(min).
To disable the Check-Weighing function enter zero into both limits by pressing the
rrent limits are shown then pressing ZERO/TARE to store the zero values.
6.5. ACCUMULATE OPERATE
6.5.1. Note
The scale can be set to ccumulate manually by pressing the
tails of selecting the method using function
Please note before every accumulate operate, scale need return to zero, and only press
ble, when weight less than 20d, accumulate operate will be invalid.
6.5.2. Accumulate operate
The weight displayed will be stored in memory when the
The display will show
accumulate operate,
be output to a printer or PC.
Remove the weight, allowing the scale to return to zero and put a second weight on. Press
display will show ACC 2
Continue until all weights have been added.
6.5.3. Memory recall
The view the totals in memory press
6.5.4. Memory clear
To clear the memory, just press
6.5.5. Automatically accumulate
Press key during selfchecking, enter setting mode, press
key to enter, press
press key to select Auto. After you set,
Press weight on platform, after stable, you will hear beep on twice, you can add or remote weight now,
scale will beep on again after stable, at last, remove all weight on platform, the last weight value will store
in memory.
6.6. ANIMAL SCALE
Let the animal on the platform, after some second, if reading data change not a lot, you can hear beep
sound and reading data will be locked.
key to move active digit, use
key to sure, press
ok (check mode OK),
P2
ACC1 and then the total in memory for 2 seconds before returning to normal (after do
indicator will turn on). If the optional RS232 interface is installed the weight will
and then the new total.
key.
and
key to select , press
Auto
USER'S MANUAL
SEt H, use key to select
key to change value, use
key to escape.
SEt H, use key to select
nG (check mode NG), no
key. See the PARAMETERS Section for de-
Coñ.
key is pressed and weight is stable.
together.
key until display show P32Coñ, press
key to sure, display will show current RS232 mode,
indicator on.
BR20 | BR30
SEt H or SEt L, press
key to clear
bEEP , press key to enter,
(no beep), press key to sure,
key when the cu-
key when sta-
EN
key
key, the
25