Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
In reading data lock mode, if you add/remove big weight, display will still update and lock new reading
data.
You can press
6.7. KEYBOARD LOCK
You can use keyboard lock when this function enable (see detail setting process in section 7), after keyboard
haven't use for 10 minutes, keyboard will be lock, after enter lock status, if you press any key, display will
show k-LCk.
If you want to escape lock mode and return work mode, hold
show ULCk, return normal mode.
6.8. SET BACKLIGHT
Hold
key 3 second, display will show SEtbL, press
change backlight mode
add load on scale,
6.9. SET AUTO POWER OFF
Hold
key 3 second, display will show SEtbL, press
key, display will show SEtoFF, press
Press
change auto power off time
power off after standby 15 minuts. Press
The indicator has 3 parameters that can be programmed by the user and a parameter to do the calibra-
tion.
The calibration can be only done by the authorized technical personnel, please, if you wish do a calibration
contact with your authorized calibration organism who is authorized to seal and to unseal the scale.
In order to enter the calibration parameter it is necessary to short the K2 jumper K2 of the main keyboard.
To set parameters press the
,
to enter.
The display will show the first function,
Pressing the
Pressing
will allow you to set the function. It may be necessary to either use
the
key to move the active digit and then using the
key to enter the value. Use the
For example when the display shows
This display will show
parameter,
SEt H i
After pressing the
the
key to increment the flashing digit. Continue to the next digit and set it as needed.
When all digits have been set press the
just st, i.e.
SEt
Lo. Advanced to another prameter if needed or press the
Parameter setting table:
26
and
together to enter/escape animal weighing mode.
(bL on
: always on,
bLoFF
: backlight always off). Press
oF
on: always on,
key during selfchecing, display whill show
PO
key will cycle through the other functions.
key to leave a parameter unchanged.
PO CHk
SEt
Lo, press the
for setting the high limit.
key to set a limit, use the
USER'S MANUAL
key to enter backlight setting, press
bL AU
: auto backlight, backlight will on when press any key or
key to sure, press
key to enter.
key to enter auto power off setting, press
oF
5: auto power off after standby 5 minuts,
key to sure, press
CHk.
key to increment a digit, followed by the
press the
key to begin.
key to set the low limit, or press the
and
keys to change the flashing digit, then use
key to store the value. The display will go back to the parameter
BR20 | BR30
,
,
key 2 seconds, display will
key to scape.
key to scape.
7. PARAMETERS
Pn
(ask password), press
or set a value using
to skip to the next
key to return to weighing.
EN
key to
key to
oF
15: auto
,
Publicidad
Tabla de contenido
