Maintenance; Cleaning - Samsung NX58M9420S Serie Manual De Instrucciones

Maintenance

Cleaning

Control panel
First, lock the control panel and the door to prevent accidental operations and/or
product tipping.
1. Press and hold the START/SET pad for 3 seconds to lock both the control panel
and the door.
2. Clean the control panel using a soft cloth dampened with plain water, warm
soapy water, or glass cleaner. Do not spray cleansers directly onto the control
panel.
3. When done, press and hold the START/SET pad again for 3 seconds.
WARNING
• Make sure the control panel turns off and all surfaces of the range are cool
before cleaning. Otherwise, you can get burned.
• If the range has been moved away from the wall, make sure the anti-tip device is
reinstalled properly when the range has been put into place again. Otherwise, the
range may tip over, causing physical injuries.
• Do not use steel-wool or abrasive cleansers of any kind. These can scratch or
damage the surface.
Stainless steel surface
1. Remove any spills, spots, and grease stains using a soft, wet cloth.
2. Apply an approved stainless steel cleanser to a cloth or paper towel.
3. Clean one small area at a time, rubbing with the grain of the stainless steel if
applicable.
4. When done, dry the surface using a soft, dry cloth.
5. Repeat steps 2 through 4 as many times as necessary.
CAUTION
• Do not use a steel-wool pad or abrasive cleanser on stainless steel surfaces. It
will scratch the surface.
• Do not spray any type of cleanser into the manifold holes. The ignition system is
located in those holes and must be kept free of moisture.
NX58M9420S-DG68-00905A-01_EN+MES+CFR.indb 33
Racks
To keep the racks clean, remove them from the cavity, and soak them in lukewarm
soapy water. Then, scour soil off of the racks using a plastic scouring pad. If the
racks do not slide in and out smoothly after you have cleaned them, rub the side
rail guides with wax paper or a cloth containing a few drops of cooking oil. This
will help the racks glide more easily on their tracks.
NOTES
• Do not put the racks in a dishwasher.
• If a rack does not slide in and out smoothly, apply a few drops of cooking oil to
the oven rack guides.
• If a rack becomes too difficult to slide in or out, lubricate the rack with graphite
lubricant.
• To purchase the graphite lubricant, contact us at 1-800-SAMSUNG (726-7864).
• For online shopping, visit http://www.samsungparts.com/Default.aspx and search
for part DG81-01629A.
CAUTION
• Do not leave the racks in the oven during the self-cleaning cycle. The extreme
heat generated in this cycle can permanently peel off the rack coating and make
it difficult to slide the racks on the guide rails.
• Do not spray cooking oil or lubricant directly onto the racks.
Door
Do not remove the inner gasket of the oven door for cleaning.
Door inner side
• Inner surface: Clean the inner side of the door manually using a soapy plastic
scouring pad, and then wipe with a dry cloth. Take care not to get the gasket wet
or allow moisture into the door.
• Inner glass: The inner glass is cleaned automatically during the self-cleaning
cycle.
English 33
2017-02-10 3:37:55