Installing Drain Spud In Bowl - Bradley WF3203 Manual De Installation

TDB3103, WF3203
3

Installing drain spud in bowl

A
SECURE DRAIN SPUD WITH LOCK NUT AND WASHERS AS
SHOWN IN FIGURE 5.
Figure 5
Supply Stop Valve connection,
4
and P-trap installation
A
USING PIPE THREAD SEALANT, THREAD SUPPLIED 1/2" STREET ELBOWS
INTO THE 1/2" ANGLE SUPPLY STOPS (SEE FIGURE 9A, PAGE 12)
B
AGAIN USING PIPE THREAD SEALANT, THREAD
SUPPLY STOPS ONTO STUB-OUTS.
FOLLOW THE PROCEDURES BELOW AND REFER TO
C
FIGURE 6 WHEN INSTALLING 3/8" TUBING INTO
SPRAYHEAD TO ENSURE THAT YOU ACHIEVE A
LEAKPROOF SEAL.
USING A SHARP KNIFE, CUT TUBING SQUARELY AND
D
REMOVE ANY BURRS. DO NOT PINCH OR CRUSH END
OF TUBING.
SPRAYHEAD
Figure 6
8
TUBING
1-26-10
Seal between drain spud and drain hole with
plumber's putty (supplied by installer).
LOOSEN NUT ON FITTING. MOISTEN END OF TUBE AND PUSH INTO
E
FITTING UNTIL IT IS FIRMLY SEATED. TIGHTEN NUT TO SECURE TUBE
TO FITTING (MAKE SURE NUT IS SECURELY TIGHTENED).
IF CONNECTOR LEAKS, RESEAT TUBING ACCORDING TO ABOVE
F
PROCEDURE. IF LEAKING PERSISTS, REPLACE MALE CONNECTOR,
OR CALL YOUR BRADLEY REPRESENTATIVE FOR ASSISTANCE.
G
CONNECT P-TRAP (SUPPLIED BY INSTALLER) TO TAILPIECE AND
DRAIN OUTLET.
Bradley Corporation • 215-1332 Rev. U; EN 10-00-002
NOTE!
NOTE!
Fush supply lines before making
connections. Do not use pipe sealant
on compression fittings.
MALE
3/8" TUBE
CONNECTOR
145-105
NUT
TUBING
Installation