Bowl/Pedestal Mounting And Assembly; Installing Drain Spud In Bowl - Bradley Terreon TDB3104 Manual Del Usuario

Installation
2

Bowl/Pedestal Mounting and Assembly

Position the pedestal at desired location and
A
mark the position of the (2) pedestal wall
mounting locations and (2) pedestal floor
mounting locations.
TAS OPTION: Place TAS spacer on floor
over the mounting holes. Place pedestal on
top of the spacer.
Secure pedestal to floor with suitable
B
fasteners, 1/2" anchors and bolts (supplied
by installer). Do not overtighten.
C
Using two to three people, carefully lift bowl
onto pedestal.
Position the bowl so that the threaded rods
D
in the bowl mate with the slotted holes in
the pedestal.
E
Using 1/4" wing nuts and washers, secure
the bowl to the pedestal, three places.
3

Installing Drain Spud in Bowl

A
Loosely attach the drain spud to the bowl
with the locknut and washer.
B TRAP OPTION: attach B trap to drain spud.
Tie Pipe OPTION: attach tie pipe bracket to
drain spud.
B
Tighten the spud and lock nut against the
bowl.
C
Secure the strainer to drain spud with the
screws provided.
D
Connect spud (or B Trap or Tie Pipe Bracket)
to drain.
Bradley • 215-1078 Rev. T; ECN 12-00-004
CAUTION! Bowl surface is very smooth. Approximate
weight of bowl is 146 pounds (model TDB3104),
136 pounds (model WF3204) or 101 pounds (model
TDB3104/JUV). Handle with Care!
Top View
Front View
Place Hands
Here When
Lifting Bowl
Wall
Mounting
Locations
Seal between drain spud and drain hole with
plumber's putty (supplied by installer).
Drain Pre-Pack
(S45-273)
TDB3104, WF3204
Drain
Threaded Rod
(Secured by 1/4"
wing nut and
Pedestal
Floor Mounting Locations
Strainer (S45-067)
Spud (112-015)
Bowl
Washer (142-068)
Locknut (161-021)
1/15/2013
Place Hands
Here When
Lifting Bowl
washer)
9