Wall Mounting, Wood Surface; Positioning Terminal On Fasteners - Mettler Toledo IND9D56 Guia De Instalacion

IND9D56 Installation Manual

Wall Mounting, Wood Surface

When mounting the IND9D56 to a wooden wall or similar surface, use four #12
screws of at least 1 1/4" (30 mm) length, each with a flat washer of minimum
1/2" (12 mm) diameter.

Positioning Terminal on Fasteners

Place the fasteners through the holes in the enclosure mounting brackets and insert
them into the holes drilled to receive them. Tighten the bolt to expand the toggle
nut, and continue tightening until the bracket is snug against the surface. Figure
2-3 shows the relationship between bracket, hardware and wall.
Figure 2-3: Wallboard or Drywall Installation
Periodically inspect the enclosure to insure that it is securely anchored to the wall.
If it is not, retighten the mounting bolts.
2-3