Inserting/ejecting the card
Be sure to use a 3V (3.3 V) card. Non-Olympus 3 V (3.3 V) cards must be
formatted with the camera. Do not use a 5 V card or a 2 MB card.
Inserting the card
3
Insert the card fully with the contact area
facing towards the monitor side. Insert
until you feel it locked into place.
● Note the orientation of the card. If it is
inserted incorrectly, it may become
jammed.
3
Ejecting the card
Push in the card lightly to unlock it, then
pull it out.
Make sure the camera is turned off (i.e. the mode
1
dial is set to OFF).
2
4
Close the cover tightly.
17