Best IM32I100SP Manual De Instrucciones página 13

INSTALL WIRING
1. Drop the ceiling canopy. Feed the
wires through the center of the ceil-
ing canopy. Wire tie the two power
cables to the support arms. Insert the
wires onto the strain relief and into
the junction box. Secure the wires by
tightening the strain relief. Make the
power connections Fig. 16.
2. Feed the wire safety cables through
the center of the ceiling canopy and
along the support arms and insert
into the cable supports as shown in
Fig. 17. Repeat for each power unit.
A. Push cable through support rods
and into hood cavity.
B. Slide washer and cable clamp
with barrel nut onto cable. Note
that the barrel nut must be slightly
backed off of cable clamp and
pushed (spring compressed)
when sliding assembly onto cable.
C. Push clamp assembly all the way
to the top of the hood while push-
ing down on barrel nut. Fig. 17.
D. When assembly is all the way to
the top inside of hood, completely
tighten barrel nut. Fig. 18.
E. Cut excess cable off.
JUNCTION
BOX
WIRE
WAY
GROMMET
HEX NUT
NOTE: CABLE CLAMP ASSEMBLY
INCLUDES BARREL NUT AND HEX NUT.
CABLE CLAMP
ASSEMBLY
- 13 -
POWER
CABLES
STRAIN
RELIEF
Fig. 16
BARREL NUT
Fig. 17
Fig. 18