Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
_<
Description-
Rear Panel
@
0
_iii
!iil
1
2
3
4
ONENT
0 OUT
ill
5
g
_T£OL
@
© QP
©©©
WOOFE_
8
1, DIGITAL OUT Jacks
Use either an optical or coaxial digital cable to connect to an AV amplifier with a built-in decoder (AV control center).
2, HD_I OUT Jack
Use a HDMI connection cable (commercially
available) to connect to a display with an HDMI compatible port.
3, AUDIO OUT Jacks
Connect to the Audio input jacks of A/V-compatible
TV or wide screen TV, Stereo system.
4. V_DEO OUT Jack
Use a video cable to connect one of the jacks to Video input on your A/V-compatible TV, wide screen T\/, or Stereo system.
5, COMPONENT
VIDEO OUT Jacks
Use these jacks if you have a TV with Component Video in jacks. These jacks provide C_/Pr_CdP, and Y video. Along
with S-Video, Component Video provides the best picture quality.
6, S-VIDEO OUT Jack
Use the S-Video cable to connect this jack to the S-Video jack on your A/V-compatible
TV or wide screen TV for a higher
quality picture.
7. REMOTE CONTROL
IN/OUT Jacks
Connecting
the DENON Satellite Remote Control to these jacks enables you to operate more than one DENON compo-
nents with one remote control.
8, 5,1ch AUDIO OUT Jacks
Use speaker cables to connect these jacks to the 5.1 ch Audio input jacks of your AV amplifier with 5.1-channel
input
terminals.
When
using
the DENON
Satellite
Remote
Control,
1. Connect the DENON Satellite Remote Control to the REMOTE CONTROL
IN jack of this player. This allows you to oper-
ate this player with the Satellite Remote Control.
2. Connect another DENON component
to the REMOTE CONTROL OUT jack of this player. This allows you to operate this
player and the connected component
with the same Satellite Remote Control.
NOTE:
,, When there is video output from the HDMI OUT jack, no signal is output from the COMPONENT
VIDEO OUT jacks.
Selecting
Progressive
Scan
(52_p/480p
or Interlaced
$2Si/480i)
Ptayback
® If your TV is compatible with progressive
scanning (525p/480p), connect the TV to the COMPONENT
VIDEO OUT jacks of
the DVD player and set PROGRESSIVE
to ON in the display setting. Next, set your TV to the progressive scan mode.
Refer to page 25 for instructions on changing the display setting. RSCAN will appear on the display of the unit.
® If your TV is not compatible with progressive scanning, set PROGRESSIVE
to OFF (refer to page 25). Make sure that RSCAN
on the display of the unit lights off.
Use a commercially
available adaptor if the video input jacks of your TV or monitor is the BNC type.
Progressive video signal will not be output from the COMPONENT
VIDEO OUT during the HDM! output mode.
What is Progressive
Scanning?
® Unlike conventional
interlace scanning, the progressive
scan system provides less flickering and images in higher resolution
than that of traditional (525i/480i) television signals.
The
DCDi (Directiona_
Correlationa_
De-interlacing)
ayatem
of this
DVD player
produces
Smooth
and
natura_
video
images,
even
if really
dynamic,
by eliminating
the jagged
edges.
DCDi
is a trademark
of
Faroudja,
a division
of Geneaia
_,4iorochip
_nc.
-11
-
EN
Publicidad
Tabla de contenido
