Skirt Height And Operation Check; Battery Charging - Clarke BSW 28 Libro De Instrucciones

SKIRT HEIGHT AND OPERATION CHECK

1. Drive the machine on a level ground that is suitable for
checking the skirt height.
2. Turn the main switch (1) to "0".
3. Check that the height from the ground of the side skirts
(A and B, Fig. 11) is within 0 and 0.08 in (0 and 2 mm).
Check the skirts for integrity, cuts or tears, which can
reduce the machine vacuum capabilities. If necessary
replace the side skirts (see the procedure in the Service
Manual).
4. Check that the front and rear skirts (C and D, Fig. 11)
slightly rub on the ground. Check the skirts for integrity,
cuts or tears, which can reduce the machine vacuum
capabilities. Note that the front skirt has typical vertical
cuts (E). If necessary replace the front and rear skirts
(see the procedure in the Service Manual).

BATTERY CHARGING

1. Drive the machine to the appointed recharging area and
ensure that it cannot move independently.
2. Turn the main switch (A, Fig. 12) to "0".
3. Remove the battery charger cable (B) from the housing
(C) and connect it to the electrical mains.
CAUTION!
Before connecting the battery charger (B),
ensure that frequency and voltage values,
indicated on the machine serial number plate
(33), match the electrical mains voltage.
In case of doubt, do not connect the plug to
the electrical mains, but contact the qualified
personnel.
4. While charging the batteries, the red warning light (D)
and the yellow warning light (E) turn on in sequence.
When the green warning light (F) turns on, the batteries
are charged.
5. Disconnect the battery charger cable (B) from the
electrical mains and place it in the housing (C).
NOTE
When the battery charger is connected to the
electrical mains, all machine functions are
automatically disabled.
Operator's Manual - BSW 28
D
A
A-B
0-2 mm
0-0.08 in
Figura 11
Figura 12
ENGLISH
B
E
C
D C
S311360
A
F
E
D
B
C
S311361
15